Subaru Legacy: If the light is blinking
If the light is blinking while driving, an engine misfire condition has been detected which may damage the emission control system.
To prevent serious damage to the emission control system, you should conform to the following instructions.
● Reduce vehicle speed.
● Avoid hard acceleration.
● Avoid steep uphill grades.
● Reduce the amount of cargo, if possible.
● Stop towing a trailer as soon as possible.
The CHECK ENGINE warning light/malfunction indicator lamp may stop blinking and illuminate steadily after several driving trips. You should have your vehicle checked by an authorized SUBARU dealer immediately.
If the light illuminates constantly
If the light illuminates constantly while driving or does not turn off after
the engine starts, an emission control system malfunction has been detected.
You should have your vehicle checked by an ...
Coolant temperature low indicator light/Coolant temperature high warning light
CAUTION
● After turning the ignition switch to the “ON” position, if this indicator light/warning
light behaves under any of the following conditions, the electrical system may be
malfu ...
See also:
Adjusting The Seat Forward Or Rearward
The seat can be adjusted both forward and rearward.
Push the seat switch forward or rearward, the seat will
move in the direction of the switch. Release the switch
when the desired position is re ...
Principle of operation
Electronic stability programme(ESP)
WARNING:
ESP does not relieve you of yourresponsibility to drive with due careand attention.
without ESP Awith ESP B
The ESP supports stability when thevehicle ...
Important Maintenance Precautions
If you have the required service
done but do not reset the display, or
reset the display without doing the
service, the system will not show the
correct maintenance intervals. This
can lead ...
