Subaru Legacy: GVWR and GAWR (Gross Vehicle Weight Rating and Gross Axle Weight Rating) - Loading your vehicle - Driving tips - Subaru Legacy Owners ManualSubaru Legacy: GVWR and GAWR (Gross Vehicle Weight Rating and Gross Axle Weight Rating)

Certification label

Certification label

The certification label attached to the driver’s side door shows GVWR (Gross Vehicle Weight Rating) and GAWR (Gross Axle Weight Rating).

The GVW (Gross Vehicle Weight) must never exceed the GVWR. GVW is the combined total of weight of the vehicle, fuel, driver, all passengers, luggage, any optional equipment and trailer tongue load. Therefore, the GVW changes depending on the situation.

In addition, the total weight applied to each axle (GAW) must never exceed the GAWR. The front and rear GAWs can be adjusted by relocating luggage inside the vehicle.

Even if the total weight of your luggage is lower than the vehicle capacity weight, either front or rear GAW may exceed the GAWR, depending on the distribution of the luggage.

When possible, the load should be evenly distributed throughout the vehicle. If you carry heavy loads in the vehicle, you should confirm that GVW and front and rear GAWs are within the GVWR and GAWR by putting your vehicle on a vehicle scale, found at a commercial weighing station.

Do not use replacement tires with a lower load range than the originals because they may lower the GVWR and GAWR limitations. Replacement tires with a higher load range than the originals do not increase the GVWR and GAWR limitations.

    Vehicle capacity weight
    The load capacity of your vehicle is determined by weight, not by available cargo space. The maximum load you can carry in your vehicle is shown on the vehicle placard attached to the driver†...

    Roof rails with integrated crossbars (Outback)
    1) Integrated crossbars CAUTION ● For cargo carrying purposes, the bars must be used as crossbars and be used together with the genuine SUBARU carrying attachment. The bars must never be u ...

    See also:

    Ignition Key Removal
    Vehicle Key Automatic Transaxle Place the shift lever in PARK. Turn the ignition switch to the ACC position, push the key and cylinder inward, rotate the key to the LOCK position, and remove t ...

    Engine number
    The engine number is stamped on the engine block as shown in the drawing. ...

    Connecting The iPod Or External USB Device
    Use the connection cable to connect an iPod or external USB device to the vehicle’s USB connector port which is located in the center of the instrument panel below the climate controls. USB ...