Subaru Legacy: Checking the oil level
AT models
1) Yellow handle
1. Park the vehicle on a level surface and stop the engine.
2. Pull out the level gauge, wipe it clean, and insert it again.
1) Upper level
2) Lower level
3. Pull out the level gauge again and check the oil level on it. If it is below the lower level, add oil to bring the level up to the upper level.
CAUTION
Be careful not to spill front differential gear oil when adding it. If oil touches the exhaust pipe, it may cause a bad smell, smoke, and/or a fire. If oil gets on the exhaust pipe, be sure to wipe it off.
CVT models
There is no oil level gauge. To check the front differential gear oil level,
we recommend that you consult your SUBARU dealer for inspection. ...
See also:
If the SRS airbags deploy (inflate)
●Bruising and slight abrasions may result from contact with a deploying
(inflating) SRS airbag.
●A loud noise and white powder will be emitted.
●Parts of the airbag module (steer ...
High/low beam headlights
Continuous high beams
1. Set the ignition to mode II.
2. With the light switch in position 0 or
, pull the turn signal lever toward
the steering wheel to position 2 to toggle between high and low ...
Protective action
Airbags are not triggered in every impact situation,
e.g., in less severe accidents or rear-end
collisions.
Information on how to ensure the optimal
protective effect of the airbags
▷ K ...
